Products from Deutsche WindGuard Wind Tunnel Services GmbH
No results were found for the filter!
Anemometer calibration, MEASNET/IEC 61400-12-1 Calibration in accordance to MEASNET/IEC 61400-12-1 at a flow speed range of 4 to 16 m/s with 13 measurement points at a tilt angle of 0°. WindGuard has also established a fixed yaw orientation for each anemometer type to achieve a high...
From € 150.00 *
Calibration at varying air pressure WindGuard operates the only commercially used pressurized wind tunnel worldwide where a measurement of pressure induced effects on wind sensor performance is possible! The wind tunnel itself is comprised of a sheet metal construction...
€ 1,250.00 *
Calibration at varying air temperature Measurements of temperature induced effects are performed in a climate wind tunnel. The whole wind tunnel is placed in an insulated and temperature-controlled chamber. Therefore, temperature induced effects on the whole anemometer can be...
€ 1,250.00 *
Calibration in accordance to EU Commission... The European Commission introduced an implementing Regulation (EU) No 595/2009 of the European Parliament and of the Council as regards the determination of the CO2 emissions and fuel consumption of heavy-duty vehicles and amending...
€ 600.00 *
Classification of Anemometers WindGuard is the leading expert in the classification of anemometers in accordance to IEC 61400-12-1:2017. The classification at WindGuard includes: - Standard MEASNET/IEC61400-12-1:2017 calibration of anemometers - Measurement of tilt...
Price on request
High speed calibration High speed calibrations (> 38 m/s) are performed in our large scale wind tunnel. Measurements of wind sensors are possible with flow speeds up to at least 90 m/s. Flow speed calibrations usually starts at a flow speed range of 10 m/s,...
From € 1,200.00 *
Inspection Thies First Class Anemometer Type... The inspection of Thies First Class Anemometers includes a visual inspection of each part, a signal test, a measurement of spindle concentricity and a leakage test of the rotor. Depending on the inspection result the further work process...
€ 20.00 *
Maintenance R. M. Young Propeller Anemometer... The maintenance of a 27106 propeller anemometer includes a detailed inspection beforehand. The inspection includes a detailed visual inspection and a signal test. The maintenance will be immediately conducted in case of a damage-free...
€ 50.00 *
Maintenance R. M. Young Wind Monitor The maintenance of a R. M. Young Wind Monitor includes an inspection with an operation test, exchange of the bearings and exchange of seals of the anemometer part only. If abnormalities or damages are detected the maintenance will not be...
Price on request
Maintenance Thies First Class Anemometer The maintenance of Thies First Class anemometers includes a detailed inspection beforehand. This includes beside the visuals inspection of each part also a signal test, the measurement of spindle concentricity and a leakage test of the...
From € 70.00 *
Maintenance Vaisala Anemometers WAAxxx The maintenance of a Vaisala WAAxx anemometer includes a visual inspection with an operation test, exchange of the bearings and exchange of seals. The maintenance will not be carried out directly if abnormalities or damages are detected....
€ 154.00 *
Starting threshold - Cup Anemometer Measurement in accordance to ISO 17713-1. The starting threshold will be determined by measuring the lowest wind speed at which the cups of the anemometer start to continuously turn and the anemometer is producing a measurable output...
€ 350.00 *